Test by entering the PIN and pressing the UP/DOWN arrow key once.While the purple light is blinking (30 seconds), go to the keypad, enter the new code you programmed into the keypad, and slowly press and release the UP/DOWN arrow key several times until the door activates.Upon releasing the square button, the blue light will turn off and the long purple button will start to blink.Remote / Keypad Programming Instructions. Press and hold the square PROGRAM button (shown in the diagram above) located on the bottom of the motor head, until the round LED turns blue and release the button. Genie garage door opener supportModel ISD995 - Excelerator®.Enter your PIN ( from three to eight characters).Test by entering your PIN and pressing the UP/DOWN arrow key once.Wait 30 seconds until the LED turns off.On the wireless keypad, enter your PIN and press the UP/DOWN arrow key 3, 4, or 5 times until the door activates.Use an existing remote to unlock the system by pressing it once only.Press the square PROGRAM button and release again.(Note: If the round, blue LED turns off and the long, purple light starts blinking, go to the instructions for Intellicode 2 below.) Press and hold the square PROGRAM button located on the bottom of the motor unit, until both the round and cylindrical LEDs turn blue. The round LED light will turn blue and then turn off. If your door opener does not have an antenna, you have an external receiver, and you'll need to remove the external receiver cover to find the LEARN CODE button and the indicator LED. Programming a Genie keypad Press and hold the PRGM/SET button. Genie garage door opener supportModel IS550 - Legacy Screw Drive Series. It is usually behind the light bulb cover, close to the antenna wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |